CO2 – main section

CO2 logger sensor NUL-260

This logger sensor is based on an electromechanical reaction between CO2 gas and the sensor.

The result of the electromechanical reaction is voltage, measured by the logger sensor. The measure units are ppm (parts of CO2 per million of air).

Note: The sensor must be calibrated before every use according to the following simple procedure: connect the sensor to the PC through a USB module or a battery module. Wait for about 15 minutes to warm the sensor and press the pushbutton switch on the CO2 logger sensor for 3 seconds. Preferably this calibration should be performed in open space. A bottle adapted to the sensor is supplied.

 


Distributors in the United States, Canada, and other countries.
facebook youtube